Specifications:
Voltage: 220V 0.1A
Power: 65 W.
Rotation speed: 4200 r/min.
Work table size: 165 x 165 mm.
Machine size: 195 x 195 x 160 mm.
Machine weight: 2 kg.
Colour: blue.
Sanding disc assembly:
1. Before installing the lubricant filled grinding disc, the motor shaft grinding discs must apply a layer of lubricant.
2. The grinding wheel is mounted on the motor shaft, the fixed screw position is higher than the motor shaft. The position of the grinding disc on the axle must be at least 1/8 inch diamond part above the operation table.
3. Attach the grinding wheel clockwise to the shaft with hex key.
Installation instructions: pay attention to the stability of the grinding wheel built into the motor shaft of the plane.
Operation note:
1. Cannot grind without water. Make sure the grinding wheel is wet
2. Do not use too much strength when using the low strength grinding wheel. Too much
Strength reduces the grinder and the life of the grinding disc.
3. Clean the water container after use. Remove the container and clean the rest of the residue.
after grinding.
4. To extend the life of the grinder, remove all the grinding discs and the fixed screw 25 hours after each use and apply lubricant to the motor shaft.
5. If the grinding wheel is not used for a week or more, it must be sanded on the stage so that the direct axis does not get stuck.
This will help you check the motor shaft, and the wheel maintains its habit.
6. Do not grind metal. When grinding metal, the grinding wheel is damaged and no glass can be sanded.
Box contents:
1 x glass sander.
1 x 5/8 inch diamond slide