Too sticky or too thick?

1. Hardly shake the gel polish before applying. Or put it in warm water, let it stand for a few minutes and then apply it.

2. Apply each thin layer is the key, make sure there is not too much gel on the brush before you start applying.

3. It is normal that the primer and color gel remain a little sticky after curing, the top coat would seal it.

Not dry?

1. Please check the wattage of your lamp. If the wattage is too low, it may not dry or take longer to cure. Recommended Wattage: 36 W.

2. Recommended curing time: Primer and each layer of paint cure with UV light for 1 minute or LED for 30 seconds, top coat cure with UV light for 2 minutes or LED for 60 seconds.

Easy to remove?

1. Use a nail file/nail dryer (before the base coat) to ensure that your nails are completely dry, clean and free.

2. Applying the base coat is an important step to prevent peeling. Base and top coat should be as thin as possible, otherwise the gel will shrink and peel.

3. Remember to seal the nail edge with each layer. And clean the gel on the cuticle before curing.