Feature

●Width and roller diameter are optimized for use with drills. Adjustable rollers at both ends for even squeezing. 12 TPI knurling to efficiently pull grain through the rollers while keeping the hull intact to form an excellent filter bed to bead through
●Cold rolled steel for the rollers and aluminium for bodywork and stainless steel funnels as well as oil impregnated brass bushings. The grain mill is professional in grinding barley, wheat and other grains. It is equipped with adjustable 2 rollers, which can chop the grain well and peel off the shell perfectly to be suitable for brewing beer in the future
●This equipment is perfect for large batches and highly efficient milling. With two rollers, your entire grain is crushed twice in one cycle. The squeezing is done by the fixed gap between the two upper rollers. The first pass easily smooths the grain and prepares it for the next crush that breaks the grains and releases the starch with minimal shell damage
●The funnel can hold up to 30 kg of grain, and the roller body features an aluminium block frame that houses three steel rollers on oil-impregnated bronze bushings. The drive shaft and all axles are integrated into the roller, allowing clockwise or counterclockwise drive. A hand crank is included, but the mill can be easily motorised with a corded electric drill
●You dont need any additional attachments, just stick the drill on and off you go. Rustproof knurled knobs allow an adjustment range for the gap spacing of .070". The adjustment is simple - simply loosen the adjustment screws, adjust the gap and tighten the adjustment screws


Description

Equipped with stainless steel rollers = wet milling possible.
Specification:
Colour: silver.
2 wheels: stainless steel.
Grinding housing: aluminium.
Funnel: stainless steel.
Speed: 3.6 kg/min.
Total height: 260 mm (10.2 inches).
Funnel dimensions at top: 220 x 210 mm (8.7 x 8.3 inches).
Grinder footprint: 140 x 80 mm (9.4 x 3.1 inches).
Roll dimensions: 76 x 150 x 50 mm (3 x 6 x 2 inches).
Single roll: diameter 38 x 150 mm (1.5 x 6 inches).
The ribbed rollers are adjustable at both ends of the slot.
Roll adjustable approx. 0.1 - 2.5 mm.
With 2 aluminium poles
Crank handle: 120 mm (4.7 inches).
Advantage:
6 inch long adjustable gap.
Fully adjustable grinder.
0.060 inch fixed primary gap, 0-0.065 inch fully adjustable secondary gap.
Two stainless steel eccentric adjusters without abrasion
8 lbs / minute is the average throughput.
6 x 1.5 inch diameter stainless steel wheels.
The crankshaft can be rotated clockwise or counterclockwise
Sturdy aluminium frame.
SAE 841 Oil Impregnated Bronze Bushings
High-performance two-roller mill with adjustable secondary gap spacing.
Integrated drive shaft and axles
The mill can be cranked by hand or motorised with a wired electric drill
You need to supply or build a base to place the mill over a grain container or a 5 gallon bucket
Box contents:
2 aluminium poles.
1 x Malt Mill.
1 piece. Funnel
1 piece. Crank handle.
Some accessories