Feature

●This module is supplied as a step control signal. The drive must also be used to control the stepper motor.
●The measurement frequency can be two PUL and GND (GND). The forward and reverse gear of the motor can be controlled by pressing the button. The speed of the motor can be regulated by adjusting the frequency of the potentiometer.
●The controller has a high, medium and low sum of three types of frequency signals that can be used to select the jumper.
●PUL + and PUL - pulsed positive and negative; EN + and EN - is supposed to activate the positive and negative connections; DIR + and DIR- are the positive and negative directions. These six lines are connected to control the corresponding pulse direction, i.e. six connections p
●Power supply: 15-160VDC or 5-12VDC If you use a voltage of 5-12 VDC, connect the positive end to the input DC 5-12V and the negative end to the common cathode end.


Description

11

Spezifikation:

Versorgungsspannung: 15-160V / 5-12V
Größe: Ca. 73 x 51 x 37 mm / 2,87 x 2 x 1,45 Zoll
Frequenz: Hoch: 5,8 KHZ-127 KHZ, Mittel: 590 HZ-15,8 KHZ, Niedrig: 82 HZ-2,3 KHZ
Gewicht: 50g
11

Durch Drücken der Taste kann der Vor- und Rücklauf des Motors gesteuert werden.

Die Geschwindigkeit des Motors kann durch Einstellen der Frequenz des Potentiometers gesteuert werden.

Wenn Sie verwenden, um die Funktion zu starten oder zu stoppen, muss der ENA-Controller-Freigabeanschluss an die gemeinsame Kathoden- oder gemeinsame Anodenansteuerung angeschlossen werden.

Paketliste:

  • 1 x PWM-Generator