Feature

●This module is supplied as a stepper drive signal. To control the stepper motor, you must also have a drive to use it
●The stepper motor controller has high, medium and low total of three types of frequency signals that can be used to select jumpers
●The frequency of measurement can be PUL and common cathode terminal (GND) two ports
●PUL + and PUL - pulsed positive and negative; EN + and EN - allow the positive and negative terminals; DIR + and DIR - positive and negative directions, six lines connected to drive the corresponding pulse, direction, so that 6 connections are possible
●Power supply: 15-160VDC or 5-12VDC If you use 5-12V DC power, connect positive end to DC 5-12V input, negative end connect common cathode end.


Description

This stepper motor controller board has the ability to generate a PWM signal. Comes with a jumper, you are able to change the standard frequency pulse signal to PWM pulse signal. The movement and reverse of the engine can be controlled by pressing the button. The speed of the motor can be controlled by adjusting the frequency of the potentiometer.

Specification:
Mains voltage: 15-160 V / 5-12 V.
Frequency: High: 5.8 kHz - 127 kHz, Mid: 590 Hz - 15.8 kHz, Low: 82 Hz - 2.3 kHz
Size: approx. 73 x 51 x 37 mm.
Weight: 50g
Quantity: 1 piece.

Box contents:
1 x PWM Generator

Note:
When starting or stopping the function, the ENA controller activated clamp must be connected to a common cathode or common anode drive.