Specifications: Input voltage: 8 V - 35 V output voltage: 8 V – 35 V Max Amps: 10A fuse/power supply: Prevent back-connect protection: Remote control distance: Less than 100 meters on/off voltage stable voltage: Yes Overtime Protection: Yes Battery Size: 12 V 23 A.

Main Control: 1) Hand Control: O is from position. Left and right side are provided for the corresponding forward or reverse control. 2) Connect to the engine element: the positive and negative side depends on your connection paths. Remote control: A: Press A, the engine will be positively forward, it will stop when loosening. B: Press B, the engine will turn negatively, it will stop when loosening. C: Press C and release. The engine will push forward positive for 1 minute and then stop. D: Press D and then release, the engine will turn negative for 10 minutes and then stop.

When using the remote control kit, please connect the two wires of the linear upgrade to the "motor" of the main controller, connect your 12V battery to "power" of the main control. For 2 linear engines, please wire them into parallel, then connect the two wires to the "motor" of the main control. Please note: If you use our linear drive, it does not need to be connected to the M or N level. Because our linear motors have built-in limit switches on the inside.

Attention: The input voltage should be between 8 V and 35 V. Please do not let water in. Please do not make the positive and reverse train in a short time. It must replace the battery in the remote control when the control distance is shorter. (Battery size: 12V 23A) The fuse could be defective if no answer is made.