Feature

●Midrange debugging: 1: no debugging is required immediately after connection. 2: Change the mid-range frequency component to increase and reduce it. 3: Change the low frequency component of the middle range to increase or decrease it.
●Triple debug: 1 - No debugging needs to be done directly after the connection. 2:?Change the high-mid frequency component of the H?hen. 3: Change the high medium and high frequency components.
●2. The crossover network is a popular end product connected to a variety of speakers. It is suitable for high and medium bass and the sound quality is the best. But not all speakers and crossover network fit best. After use, there may be too much or too little highs, low frequencies and low frequencies of the bass, low frequencies or too thick bass and too much or too little radio frequency components in the middle range.
●1. The crossover network is suitable for triple + mid + bass speakers. The speaker is suitable for 4-8 ohms. The finished products are also mainly used for better coordination. Sound quality?, give debugging accessories at the same time of purchase.
●Bass debugging: 1: no debugging is required directly after connection? 2: Change the low and mid frequency component of the bass. 3: Change the low and medium frequency components of the bass to reduce them.


Description

Yeruvce product parameters:
Frequency point: 1000 Hz / 7000 Hz (i.e. the bass works at frequencies below 1000 Hz, the middle range between 1000 Hz and 7000 Hz and the heights work ¨¹ber 7000 Hz).
Power: 200W
Impedance: 4-8 Ohm
Circuit: determined by debugging from 6db/oct to 12db/oct.
Colour: red
Material: PCB

Package contents:
2 x audio speaker crossover.

Includes only the aforementioned package contents, other products are not included.
Note: Due to lighting and monitor settings, the colour shown in the photos may differ slightly from that of the actual product. The allowed measurement error is +/- 1-3 cm.