Feature

●The signal is shown in the picture
●The connection method is shown in the following figure after ENA ENB has been activated
●Drive a DC motor. As the module is powered by a double H bridge, it can drive two motors at the same time
●Enter the following driving time from IN1-IN4, then the speed and direction of the stepper motor can be controlled
●Package includes: 5 pieces L298N motor driver controller board modules


Description

Specification:
Chip: L298N.
Logic voltage: 5 V.
Logic current: 0mA-36mA.
Storage temperature: -25°C to +130°C.
Operating mode: H-bridge driver (dual).
Drive voltage: 5V-35V.
Drive current: 2A (MAX single bridge).
Maximum power: 20W (T = 75℃)
Dimensions: 43 x 43 x 27 mm.

Note:
This module has a built-in 5V power supply. If the control voltage is 7 V to 35 V, this power supply is suitable for power supply. Do not enter voltage to the + 5 V supply interface. However, it is possible to output 5 V for external use.
When ENA IN1 IN2 is activated, control OUT1 OUT2
When ENB IN3 IN4 enabled, control OUT3 OUT4

Product Name:
L298N, L298N motor driver, L298N motor, L298N driver, L298N H bridge