1. Why does the laminator smell so bad when using?
When the device is new, the protective layer on the rollers and heating elements creates an odour. The smell (not dangerous) is normal and disappears after a few runs.
2. Why does the laminating bag stay stuck in the laminator?
There are two main causes for this:
If inferior laminating sleeves have been used, excess glue may have accumulated on the roller. Make sure the laminating bag is at the opening of the device to avoid uneven or oblique flow.
3. Is it normal that the top of the laminator is very hot?
Yes As the heating elements are wrapped around the rollers, there is a build-up of heat on the laminator housing.
4. Why is the laminating bag larger than the document?
Laminating sleeves should always have a laminating edge of 2-3mm on each side so that the document is fully encapsulated and protected.
5. How do I laminate a document smaller than the laminating bag?
Do not cut the laminating bag before laminating. Laminate the document according to the instructions: Make sure the left and right edges of the laminating bag are the same. and cut the laminating bag after laminating.