Feature

●Two types: There are two types of PWM signals, PNP PWM output and NPN PWM output; the PNP PWM output only has a 5V level, the NPN PWM output has a 5V and a 24V level.
●Wide application: the digital signal voltage converter can be used for industrial panel PLC or other signal interface circuits.
●Features: The digital input signal of this PWM signal converter can be a 5V or 24V level of 0-100% PWM signal. The analog output signal can have a voltage of 0-10V
●【Note】After power on, if there is no input signal, the output is 0V. There is only one output when there is an input.
●Customer service: We strive to provide you with the highest quality products and the best customer experience. If you are not completely satisfied, please feel free to contact us at any time.


Description

Specification:
Condition: 100% Brand New and High Quality
Current: max. 12 mA.
Input voltage power supply: 12-30V.
Size: approx. 5 x 4.5 cm / 1.97 x 1.77 inches.
Weight: 20g
Quantity: 1 piece.

Method of use:
Input frequency range of PWM signal: 1KHZ-3KHZ
Input level range of PWM signal:
4.5V to 10V peak peak level, jumper used at 5V This type mainly signals for conventional industrial control cards (e.g. for MACH3 boards), for 5 V the CPU interface.
12 to 24V peak to tip level, jumper plugged at 24V This type signals mainly for conventional PLC interfaces

Explanation of the analog voltage output from 0-10 V:
When the signal input port is not connected, the output port outputs 0V. When we turn on this module for the first time, we calibrate it better: find a signal with a duty cycle of 50%, connect it with DIN, DIN+, the amplitude corresponds to the corresponding jumper. If the frequency is at 1 kHz ~ 3 kHz, use a multimeter to test AO, GND. The gauge should display about 5.4V. We adjust the potentiometer on the converter module so that the multimeter shows about 5.4V. After this is done, we calibrated and adjusted the pulse signal with this converter module. The module has a definition of 0.1V. Output current 10mA. If the duty cycle is opposite to the voltage, we can select the PWM output pin STEP LOW / ACTIVE for the MACH3 software.

Package includes:
1 x PWM signal to voltage converter.