Feature

●6 pieces clear adhesives replacement for dashboard pad mounting disk / suction cup items: AZXYI offers 6 pieces round clear sticky adhesive pads (diameter: 80 mm, 3.15 inches) for attaching the dashboard mounting disc of your suction cup dashboard phone holder. You can also stick the transparent adhesive directly to the suction cup without affecting the appearance of the suction cup.
●Easy to use: To maximise the adhesive contact, please clean the adhesive surface before use and let it dry, free from impurities and wait at least 24 hours. First peel off the white side of the adhesive and stick it on the car mount. After applying some pressure on the adhesive, peel off the red film side of the adhesive and stick the car mount on your dashboard/windscreen.
●Cut to any desired size and compatible with suction cup base: you can cut pads into smaller pieces if necessary. Compatible with most suction cup dashboard mount and other windscreen long sleeve mount, GPS holder, EZ Pass/I-Pass/SunPass holder, camera holder, ETC, wireless charging base, dashboard mount, etc. on the market.
●Easy to install: rounded rectangular raised label for easy peeling of the red release film of the adhesive pads. Press down repeatedly to increase the contact of the adhesive with the substrate.
●Very high bond and easy to remove: with these high-strength, double-sided adhesive pads, you can quickly and easily create a permanent bond that is glued almost immediately without drying time. It also resists heat and moisture and protects adhesives from scratches, and is easy to peel off without leaving any sticky residue.


Description

AZXYI 6 Pack Very High Bond Sticky Suction Cup Adhesive Replacement for Car Dashboard WindShield Mount.

Why do we need this glue replacement?

Your teat is not strong enough and often falls off?

Your suction cup holder has lost its stickiness due to exposed outdoor systems or frequent disassembly over a long time?

If you want to lock your magnetic wireless charger in a place that is frequently used, such as office desk and car dashboard. These adhesives can help you organize your magnetic wireless charger.

Try our super glue for Lock Sucker. Never fall again!

No more adhesive separation. No more adhesive residue.

How to apply the adhesive?

Step 1: Clean the adhesive surface

Step 2: remove the white film of the adhesive and stick to the suction cup holder or charging station (you can cut into the size you are satisfied with)

Step 3: Press the adhesive approx. 15 seconds, and then peel off the red release film (pay attention to the correct adhesive position first).

Step 4: Finally, press the items firmly on the dashboard, windscreen or desktop for 10-15s after sticking.

Note:

1. Please wait 24 hours to ensure that the sticker has the best adhesion after gluing.

2. Confirm the surface is clean and dry.

3. Do not stick the adhesive to silicone, high texture and soft case.

4. Each very high adhesive is for single use.