Tank sensor / immersion tube sensor for water, petrol, diesel.
For tank watches 240/33 Ω range.
This is a multifunctional axial tank sensor submersible tube sensor,
which can be used for fuels as well as for water tanks.
The immersion tube sensor offers many advantages, exact decrease of the filling levels in the tank.
by axial swimmers. No adjustments required when installing.
No oxidation on moving parts or potentiometers as with levers.
Can be exchanged for lever encoder, only value the ohm
Attention.
Item features:
Available in lengths from 15 cm to 120 cm.
Ohm range 240-33Ω
12 and 24 volt operation possible.
Reed contacts measure very accurate every 2 cm
Internationally standardised 54 mm 5-hole flange.
For fuel and water tanks.
Seal and M5 x 10 mounting screws included.
Immersion tube and flange made of stainless steel.
CE marking.
Before you order:
Measure the depth of your tank, from the flange of your existing tank.
to tank bottom. If you want to keep a reserve in the tank, pull
1 to 2 cm of the total length.
Determination of the ohm value:
Disassemble the sensor cable, switch on the ignition and note the fuel indicator.
Tank needle does not move, stays on zero system with 240/33 Ω.
Tank needle fully strikes - system with 10/180 Ω.
Installation:
Tank sensor is mounted from above, do not fit or use lubricants.
Terminal cable back on terminals, ground (battery) and transmitter cable.
Please note: no positive line (battery+) on the sensor or tank. !
In our shop you will also find 10/180 Ω immersion tube transmitter