Technical data MHI1300: Output: 1300 W; Voltage: 230 V / 50 Hz; Protection class: IPX4; Max. discharge height: 55 m (equivalent to 5.5 bar); Max. pressure: 5.5 bar; Max. flow rate: 6000 l/h; Max. water temperature: 35 °C, 5 wheels made of stainless steel, robust and rust-proof stainless steel shaft, max. suction height: 8 m at 1 inch (2.54 cm) and check valve, connection suction and pressure side: 1 inch (2.54 cm) IG, integrated thermal motor protection switch, cable length: 0.80 m; Total weight: approx. 12.5 kg; Size: Length: 44 cm. Width: 15 cm. Height: 17 cm. Technical data Brio SK-13: Automatic on/off of the pump when the tap is opened/closed, built-in check valve and integrated dry running protection, with integrated pressure gauge, rated current: approx. 10 A; operating voltage: ~230 V ± 10% / 50 Hz. Connection: Input and output each 2.54cm (G1”) male thread; Max. Connection power: approximately 1.1 kW, Max. operating pressure: approx. 10 bar, Max. water temperature: approx. 60°C; Protection class: IP65; Volume flow: approx. 150 litres/minute. The pump and the automatic switching are supplied as a kit for self assembly (without wiring). The cable of the pump and the supply line must be connected to the automatic switch on site. Important information: The pump should be placed near the well hole if possible to achieve the max. suction height. Please equip the intake line with a check valve so that the water column (throughout from the water level to the pump) is ensured. Please fill the pump and the suction line with water before starting up, otherwise there is a risk of dry running. The suction line should have a diameter of 1 inch to 1 1/4 inches, but not smaller or larger. Otherwise the pump cannot provide the corresponding power or pressure.