Feature
●Practical set: the set contains 1 x high-quality submersible pump, 1 x pressure switch PC-59 and 1 x compression fitting with external thread for PE pipe. The submersible pump, pressure switch and connector are suitable for drinking water pipes, i.e. water pipes. They are ideal for any irrigation system in the home and garden. The pump has overheating protection and a capacitor built into the motor winding, as well as a 20 m long power cord with plug.
●High-quality materials: intake/pressure body, housing, shaft and rotor, impeller, diffuser: stainless steel AISI 304; mechanical gland: ceramic/Sic/NBR, motor: oil-cooled
●The PC-59 controller is an electronic device for controlling the pump. It controls the operation of the pump by examining changes in line pressure and water flow in the pipe. With its user-adjustable on/off pressure, the device completely replaces conventional pressure switches. The device also protects against dry running. Note: The pumps on/off pressure can be adjusted if a hydrophobic tank is used in the system.
●Note: The pumps on/off pressure can be adjusted if a hydrophobic tank is used in the system.
[3 | 5 SDM 3-11 & PC-59 & verbinder 40mm 1.1 & 2 ]
[3 Ti 20 550W & PC-59 & verbinder 40mm 1 ]
Description
The 3 inch Ti 20 pump is a multi-stage submersible pump with improved sand resistance. This effect was achieved by using floating wheels and the selection of wear-resistant materials such as brass, stainless steel and high-quality plastics. The use of an oil-filled motor allows for smooth and trouble-free operation. Thermal protection is built into the motor winding. Thanks to the built-in capacitor, an external starter box is not required. A 20 m long cable protected by a stainless steel shield is included. The pump is suitable for the water supply of single-family houses and holiday homes, but also for agricultural enterprises or industrial plants. It can also be used for garden irrigation. Thanks to its small size, it can be installed practically in any fountain. The pump allows water removal from drill wells, deep wells and other water removal points.
Technical data:
- Maximum discharge height: 82 m.
- Maximum flow rate: 50 l/min.
- Rated power of the motor: 550 W.
- Voltage: 230 V.
- Current: 4.2 A.
- Maximum temperature of liquid: 35ºC.
- Maximum ambient temperature: 35ºC.
- Height: 121 cm.
- Tap: 1 inch (DN25).
- Diameter of the pump: 74 mm.
- Insulation class: B.
- Operating mode: continuous.
- Safety: IP68.
- Motor speed: 2850RMP.
- Cable length: 20 m.
- Weight: 12 kg.
- Pressure/intake manifold: brass
- Casing: stainless steel.
- Shaft and rotor: stainless steel.
- Impeller: Noryl.
- Diffuser: Noryl
- Mechanical seal: ceramic/si/NBR
- Motor: oil-cooled.