[24v 3210yd-24-120fs]
[12v 3210yd-12-120fs]
Specification:
Maximum power: 120 W.
Maximum pressure: 13 kg.
Working pressure: 8G.
Opening flow: 10 L/m.
Vertical extraction: 1.5m
Lift: 130 m.
Package list:
1 x pump.
1 x filter net.
1 x pump handle.
3 x installation screws.
1 x replacement fuse.
Note:
1. Actual product colour may vary from the photo due to lighting conditions.
2. There may be a slight deviation in the measurement of the product.3. Please note that this product has no function to control the tap. 4. When the product is connected to a tap, it is necessary to ensure that the tap is turned on. If the tap is not turned on, the pump is dry and the pump burned out.
Instruction manual:
1. Connect the pump to the inlet and outlet lines. It must be ensured that the connection between the inlet and outlet lines and the pump is tight, otherwise there will be negative pressure or water leakage. (Note: There are arrows on the pump lid indicating the direction of water inlet and outlet, and the direction of the arrow is the direction of water outlet)
2. Install the filter at the inlet end, and the filter density is preferably above 80 mesh. (i.e. 80 holes per square centimetre).
3. Connect the micro diaphragm pump to the motor. The electrical parameters of the connected power supply must meet the input requirements of the motor.
4. Turn on the power and the motor pump starts to run.
5. The water is drained for 5~10 seconds, deflate the air in the pump and pipeline. After the water is stable, temporarily turn off the power and connect the water gun or pump head.