Feature

●High performance: WS55-180 is a powerful, cost-effective 3-phase BLDC motor controller. The voltage range ranges from 20VDC to 50VDC.
●Practical to use: the controller can use the DLDC motor with Hall or without Hall, which can be very convenient and suitable for your use.
●Multiple uses: this controller can be used in small devices, power tools, exhaust fan, jade grinder, vibration motor, etc. protection, less phase line. Protection, short circuit protection of phase line, alarm output, speed signal output, industrial automation
●Main function: when the engine stops running, the standby current is automatically reduced to half the working current, which can reduce the heat of the driver.
●Two modes speed reduction: external potentiometer: through this potentiometer speed control. External voltage: external 10 VDC voltage speed control. DIY enthusiasts can decide to use it


Description

Specifications:
Rated voltage: 20 to 50 VDC.
Rated current: 10 A.
Current limit: 15 A.
Maximum speed: 20000 rpm (the specific speed depends on the motor itself and on the load).
Storage temperature: -20°C ~ +65°C.
Application environment: avoid direct contact with dust, fumes and corrosive gases
Temperature: 0-45°C.
Moisture: <80%, no frost, frost-free.
Shock: 5.9 m/S2 Max.
Storage humidity: 0~95%RH
Size: 9.5 x 7 x 3.5 cm / 3.74 x 2.76 x 1.38 inches.
Weight: 260 g.
Detail:
1. Two modes of speed regulation:
External potentiometer: through this potentiometer speed control;
External voltage: external 10VDC voltage speed control;
Note: the two speed control can not be used at the same time
2. Positive inversion function:
F/R: Fiddle the toggle switch on the corresponding side, the steering direction of the motor can be changed. For the toggle switch, the white part is up and down, then it swung up and down. For the toggle switch, the white part is horizontal and the twang horizontal.
3. Start-stop (two control modes):
1. External Switch EN: Transmission by switch.
2. Side toggle switch EN: for the toggle switch, the white part is up and down, then bottom for start; for the toggle switch, the white part is horizontal and then for starting.
Note: you can only rotate one control at the same time, one of the switches is closed and the other is valid.
4. Blocking protection: when the motor stops working, turn on the power again to start.
1 x motor driver controller with cable.