Feature(may vary by option.)
●Extremely low-noise Class A JFet amplifier
●27 dB gain (@3 kOhm load)
●Robust housing with balanced XLR input/output
●Frequency response 10hz-100kHz (+/- 1dB), Z-in 22kΩ
●The circuit is powered by 24-48V phantom power
●Note: 1. The information that P24 or P48 is required is available. 2. A FetHead works with all types of dynamically balanced microphones. 3. A FetHead can be attached to either end of the microphone cable where it is best suited
[Bundle with extension tube]
[Single]
[Bundle with vocal microphone]
[Bundle with wind protection]
Description
class="celwidget pd_rd_w-JIyZP pd_rd_r-QKJG04TAZA620SFWGXTC pd_rd_wg-e8Agr" data-feature-name="aplus" data-csa-c-type="widget" data-csa-c-content-id="aplus" data-csa-c-slot-id="aplus_feature_div" data-csa-c-asin="" data-csa-c-is-in-initial-active-row="false" data-csa-c-id="9h5ucx-7i1c0e-n02trc-p90r39" data-cel-widget="aplus_feature_div">
From the manufacturer
TritonAudio - FetHead
Small, compact, but, powerful, Fethead utilizes tried and true FET technology to deliver up to 27dB of clean boost.
No more cranking your mic preamp and adding unwanted noise to get your microphone to an acceptable volume
- Circuit is powered with 24-48V phantom power, but does not pass this on to the microphone.
- 27 dB amplification (@ 3000 Ω Load)
- Balanced XLR input/output
- Lots of headroom
- Frequency response 10hz-100 kHz (+/- 1dB)
- Z-in 22 kΩ
- Circuit is powered with 24-48V phantom power, but does not pass this on to the microphone.
- Low noise Class A FET amplifier
FetHead is an ultra-low noise, high quality, in-line microphone preamplifier. It provides improved sound for ribbon and dynamic microphones
Your Fethead will latch straight onto any XLR equipped microphone, or anywhere else in the signal
path between microphone and preamp/mixer.
Fethead uses phantom power to power its circuitry, but doesn’t pass phantom power to the microphone, so rest assured your ribbon mics are safe.
|
|
|
|
|
|---|---|---|---|
|
|
|
|
|
