Feature

●Function: This module can convert 0-1 PWM digital signal into analog signal.
●This module can convert a digital 0PWM signal into an analog signal.
●Module operating voltage: 15-30V DC (power requirement of power supply: >100mA), PWM signal reception frequency range: 100Hz-3KHz (1-3kHz is recommended). The analog output signal can have a voltage of 0-10V.
●Analog Output Signal The analog output signal can be a voltage of 0-10V.
●The analog output signal can have a voltage of 0-5V. Receiving frequency range of PWM signal: 100Hz to 3kHz (1 to 3kHz is recommended)


Description

Specification:
1. Model: 3.3P-5V.
Function: input 0-100% PWM signal with 3.3V level, output 0-10V voltage.
2. Receiving frequency range of PWM signal: 100Hz-3KHZ (1-3kHz is recommended)
3. Plug in pin at 5 V.
4. Analog voltage output: Below is the output voltage of 0-10V for illustration. After switching on, if there is no input signal, the output is 0V. When first switched on, a calibration can be carried out: enter a signal with 50% duty cycle and 3.3V amplitude to DIN and DIN+. The frequency is 1-3 kHz. Use a multimeter to measure two ports of AO and GND. Adjust the potentiometer on the board so that the multimeter shows 5.40V. These calibrate the corresponding relationship between pulse signal and this module. The resolution of this module is 0.1 V. The output current capability is 10 mA. If the percentage of the duty cycle is in inverse ratio to voltage, you can check the STEP LOW, ACTIVE check box to set the pins of the PWM output in the software.
5. Supply voltage: 15-30 VDC (power supply requirement: >100 mA), 12 V adaptable.
6. Output power: approx. 10 mA.
7. Mounting method: 4 x M3 screws