Feature
●1. High-quality DC-DC reverse converter: voltage regulators are often used in golf carts, club cars, motors, speakers, GPS, car displays, LED light strips, air conditioners, electric fans, solar energy, DVDs and other devices that require a power supply DC 12 V voltage.
●2. Parameter specifications: DC 24/36V/48V (input range of voltage converter: 20V to 60V). It is recommended to use a stable DC power supply as an input power supply. Output voltage: DC 12V (output current: 20A) The maximum output power is 36W.
●3. Multiple protection: the step down converter has high-quality electronic components and a waterproof (IP67) aluminium housing. Built-in protection against overheating, over-current, over-voltage and short circuit to ensure the safety of your devices.
●4. Easy to use: the DC-DC converter is simple to set up and easy to install. Connect the input cable to the power supply and the output cable to the device used. The wiring diagram is attached to the back of the step-down converter.
●5. Note: Please do not open and swap the input and output ports until the circuit and connections are complete. Two input lines = red line (positive) + black line (negative). Two output wires = yellow wire (positive) + black wire (negative).
Description
|
|
|
|
|---|---|---|
Material:High quality DC-DC reverse converter with high-quality electronic components and waterproof (IP67) aluminium housing. |
Multi-wire wound sendust ringInductor FE-SI-al magnetic ring, high temperature resistant, ultra-stable electrolytic capacitor, ultra-deep impedance, 20mq105ccm, works for more than 10,000 hours |
Aviation Grade Aluminum Alloy CaseOne-piece super heat department adopts high-quality aviation aluminium cooler, integrated aluminium alloy heat dissipation design |
Wiring mode:
Input red cable +, black cable - output yellow cable +, black cable - Connect the input cable to the power supply and the output cable to the device being used. The wiring diagram is located on the back of the step-down converter. Please do not open the input and output ports or swap them until the circuit and connectors are complete. Two input cables = red cable (positive) + black cable (negative). Two output wires = yellow wire (positive) + black wire (negative).
