Feature

●This driver uses BTS7960 chips, consisting of high-power drive full-H bridge driver module with thermal overcurrent protection.
●Double BTS7960 H bridge driver circuit, with a strong drive and brake, effectively isolates the microcontroller and motor driver. High current 43 A
●Double BTS7960 Large Current (43A) H Bridge Driver
●5V isolate with MCU, and effectively protect MCU.
●Requires only four lines from MCU to driver module (GND. 5V PWM1 PWM2)


Description

Specification:
Double BTS7960 Large Current (43A) H Bridge Driver
5V insulated with MCU and effectively protects MCU
5V power indicator on board.
Motor driver output voltage indicator.
Can solder heat sink.
Requires only four lines from MCU to the driver module (GND. 5V PWM1 PWM2).
Insulation chip 5 V power supply (can share with MCU 5 V).
Dimensions (L x W x H): 5.5 x 5 x 4 cm.
Weight: 67g
Can reverse the motor forward, two PWM input frequencies up to 25kHz.
Two heat streams that perform an error signal output.
Insulated chip 5V power supply (can be shared with the MCU 5V), also can use the built-in 5V power supply.

Electrical Power:
Input voltage: 6V-27V.
Maximum current: 43A
Input level: 3.3-5V
Control: PWM or Level
Duty Time: 0-100%
Input port:
1. RPWM: forward level or PWM signal input, active
2. LPWM: reverse level or PWM signal input, active.
3. R_EN: Forward drive allows input, high-level, low-level off.
4. L_EN: Reverse drive allows input, high level capable, low level off.
5. R_IS: Power alarm output after driving forward.
6. L_IS: reverse power alarm output
7. VCC: +5V output, 5V power supply connection with the microcontroller.
8. GND: signal common low end.

Package includes:
1 x Motor