Your project?
Now you have a picture in front of your eye! A neat and safe workmanship is important to you. Always pay attention to a sufficient cross section
I want to explain here why this is so important. If the cross section is too thin, the cable will be hot. Cable burn is the result. Now I dont want to paint the devil on the wall, but choosing a cross section one size larger can not harm. To calculate the correct cross section, I recommend you find the treat plug cable calculator in this internet network.
The cross section 10 mm² corresponds to the diameter: 3.57 mm. The cross section 16 mm² corresponds to the diameter: 4.51 mm. The cross section 25 mm² corresponds to the diameter: 5.64 mm. The cross section 35 mm² corresponds to the diameter: 6.68 mm. The cross section 50 mm² corresponds to the diameter: 7.98 mm. The cross section 70 mm² corresponds to the diameter: 9.44 mm
|
|
|
---|---|---|
If you connect high-quality devices with inferior cables, do not use a large part of the achievable quality. Treat your installation environment to high-quality cables. If you want to get the most out of your installations, you need not only to cable precisely, but also find the optimal connections. The structure of the entire chain significantly determines the weakest link. Often it is the cables. Therefore, you should not save at the wrong end. |
Pre-assembled battery cable in flexible design. The cable is easy to bend and therefore adapts perfectly to the environment. The ring eyelets used are of high quality - can be recognised by the high wall thickness and excellent conductivity |
The battery cable is suitable for a voltage of 12 V or 24 V. Our cable is suitable for your car battery or starter battery. In the area of car/car as well as for quad, scooter, moped or moped. Of course, the range of winches, marine / boat sattery or for caravan motorhome is also covered. |
Battery cable made in Germany, flexible and perfect workmanship, made in Germany. High material quality with genuine 99.9% copper content. Heat resistance of the PVC H07VK sheath up to 70°. Temperature resistant minimum bending radius not moved < 8 mm: 4 x outer diameter 8 - 12 mm: 5 x outer diameter > 12 mm: 6 x outer diameter PVC according to DIN VDE 0207 - 363 - 3 / DIN EN 50363 - 3 (mix type TI1) extremely high copper content