Specification:
Item Type: Depth Gauge
Material: 316L stainless steel + anti-fog glass.
Installation diameter: approx. Φ52 mm/2 inches.
Depth display range: approx. 100 m / 110 yd.
Backlight: white.
Operating voltage: 9-32VDC.
Working current: ≤ 60 mA.
Working temperature: -30°C to +75°C.
Storage temperature: -40°C to +85°C.
Protection class: IP67, the back cover is IP5
Operation:
A. This unit only works with a 12V system to indicate the set depth. Usually the buzzer beeps once when connected correctly, and then turn on the power supply.
B. "Mode" keypad: quickly press the "Mode" keypad to switch between SH/DP/KL/UN. Press and hold the "Mode" keypad to turn the monitor on/off. Short press the "▲"▼" buttons to set the desired value. Press and hold the keypad "▲" "▼" to keep the digital rise/fall flowing.
Parameters: SH: (Low level alarm) Range: 0-0.6-19.9, when the level is no more than the set value (SH), the symbol flickers and the buzzer beeps all the time If SH = 0, no alarm alarm setting range is 0.6-19.9
Range:
1. Unit "M": 0-99.
2. Unit "FT": 0-199
3. Unit "F": 0-49 When the level exceeds a certain value, the buzzer beeps twice keel offset (KL):
Range:
1. Unit "M": 0-6.0.
2. Unit "FT": 0-19.9.
3. Unit "F": 0-3.3.
Installation Notes:
1. Drill a 52mm/2" diameter hole in the trim of your cabin trim and instrument panel, insert the instrument into the hole. The board corresponding to the instrument panel is marked with a protrusion, and leave a small notch at this position to ensure that at least 52 mm/2 inches of the