Feature

●The rim sealant is a high-quality gel product that eliminates leaks on the contact surfaces of the tyre bead and rim
●Allows you to pre-seal the surface after assembly and effectively inflate the wheel to the appropriate pressure
●Particularly recommended when installing Ultra High Performance (UHP) and Run Flat Tyre (RFT) tyres, which can cause leaks immediately after assembly due to the bead construction
●Eliminates leaks between tyre bead and rim
●Complements minor imperfections in the tyre bead level
●Prevents movement of the tyres against the rim (anti-glide)
●Increases the safety of the ride and the quality and longevity of the wheel balance
●The sealant can also be used for installing tubeless valves in the sockets of the rim rings


Description

Sealant Rim Sealant RS 1000 ml Dura-Vulc

The sealant Rim Sealant is a high-quality gel product that eliminates leaks on the contact surfaces of the tyre bead and rim. It is designed for tubeless tyres.

Particularly recommended when installing Ultra High Performance (UHP) and Run Flat Tire (RFT) tires that may cause leaks immediately after assembly due to the bead construction. The sealant can also be used to install tubeless valves into the bushings of the rim rings.

The sealant is black. There is a brush in the container (attached to the cap), making storage easier without the risk of drying out after use.

The advantages of the rim sealant Rim Sealant.

• Eliminates leaks between tyre bead and rim.
• Complements minor defects in the tyre bead level,
• Prevents movement of the tyres against the rim (anti-glide).
• Increases the safety of the ride and the quality and longevity of wheel balancing.

How to use the rim sealant.

• Before applying the gel, thoroughly clean the tyre bead and rim on the adhesive surface.
• Make sure that both levels have no excessive damage that may not ensure leakage after inflating the wheel,
• Surfaces should be dry before application, free from dust, rust and other impurities.
• Apply a thick layer of gel to both surfaces.
• Mount the tyre directly after applying the sealant without drying it.
• Pumping to the prescribed pressure is possible after at least 15 minutes. After this time, check the tightness of the connection in the area of the tyre bead.