Feature

●The stand is made of lightweight aluminium alloy. The outer square tube has a diameter of 35 mm and the inner square tube has a diameter of 31 mm. This ensures a high load capacity and stability.
●This photovoltaic stand holder is suitable for solar panels of all sizes.
●The bracket is equipped with stainless steel screws and the hole locations are precisely pre-drilled to ensure easy installation and adjustment. The main accessory is already pre-installed.
●The tilt angle can be adjusted by adjusting the length of the inner square tube. The height is individually adjustable from 40 mm to 66 cm.
●This bracket is suitable for installing solar panels on flat roofs, walls, floors, balconies, in garages, motorhomes, yachts, boats and other applications.


Description

Variable stand 15-30° for roof and wall mounting.

Solar panel holder for solar panels of all sizes, suitable for both roof and

Wall mounting - individually adjustable and adjustable. Use to attach the stand

Use the included screws/nuts and mount the holder easily and securely

the already existing mounting holes with the solar panel. The practical and adjustable

(long supports) attachments offer the possibility to position the solar panels flexibly and

also at the angle of attack. You can adjust the angle to the sun in any season perfectly and

customize. Brackets are ideal for facades, flat roofs or on any solid surface.

The set consists of: two short supports for attaching to the lower frame of the solar panel - two long

Supports (adjustable width) for attaching to the upper frame of the solar panel - eight rubber pads and

Eight M8 screws - fixing nuts are pre-screwed.

For assembly, you will need: Allen key for the locking screws - a 10 and 13 open-end wrench for

the screws and nuts. Do not turn the screws too tightly first and tighten only at the end; after the

Correct alignment, the screws are securely and firmly. The included screws are pre-installed on

compatibility with the existing structural substructures.

Instructions:

A.) Attach the short supports to the bottom frame of the solar panel.

B.) Mount the short supports with the rubber pads underneath to the chosen place (roof surface/wall) using the M8 screws.

C) Attach the long supports to the top frame of the solar panel with the brackets.

D.) The long supports with the rubber underlays laid underneath using the M8 screws to the chosen place