Features:
1. Sprockets are usually mounted in a fixed position on a fixed shaft. Keyway with 2 adjusting screws at 90 degrees. The shaft can be fixed well, which is convenient to use.
2. The sprocket should not rotate at a higher speed than is permitted for drive sprockets of the same size. Each roller sprocket is equipped with strong teeth that can latch into the chain. It is recommended that sprockets have at least three teeth that comb with the chain.
3. The product is made of C45 carbon steel, the high temperature quenching heat treatment of the tooth part, high hardness, wear resistance, long service life, easy to use. Fully black oxide coated, rust resistant.
4. Widely used in milling machines, drills or other occasions to transfer machines.
Specifications:
Material: C45 carbon steel.
Surface: Black Oxide
Number of teeth: 25.
Outer diameter: 54 mm / 2.13 inches.
Butt width: 12 mm / 0.47 inches.
Total width: 15 mm / 0.59 inches.
Bore diameter: 10 mm / 0.39 inches.
Groove size: 4 x 1.8 mm / 0.16 x 0.07 inches (L x W).
Spacing: 1/4 inch / 6.35 mm.
Tooth width: 2.7 mm / 0.11 inches.
Adjusting screw size: M5.
Package includes:
1 x sprocket.
2 x set screws