Feature

●★★★★★【Current setting】 Adjust the CC A-ADJ potentiometer about 30 circles counterclockwise to minimize the output current before connecting it to the load. Then set CC A-ADJ clockwise to the current value. If you use the module to charge the battery, connect it after the battery is fully discharged. Because the more energy remains in the battery, the lower the charging current.
●★★★★★【Voltage Adjustment】When the module is disconnected from the load, turn on the module and adjust the V-ADJ potentiometer clockwise to increase it, and counterclockwise to reduce it. Due to the large output capacity, the response is slow when the high voltage is set to low voltage.
●★★★★★【Double Sendust Magnets】The power module is a 10~60V to 12~90V DC power supply module. It uses double Sendust magnets wrapped with 1.2mm copper wire. 100V / 210A low impedance MOS with high power and current consumption, suitable for high-performance LED motors
●★★★★★【Reverse Input Protection】 Supports reverse input protection with MOS, so you dont have to worry about wrong input lines and burning out the power source. The thickened heat sink and intelligent temperature-controlled fan dissipate heat better.
●★★★★★【Low voltage protection at input】When we set the low voltage protection at the input for a 12V battery, connect the input to a voltage of 10V and adjust RV1 (clockwise to increase, counterclockwise to decrease) until UVLO lights up. Now the protection voltage is 10V, that is, when the battery voltage drops to 10V, the module does not increase the voltage and the output voltage corresponds to the input voltage.


Description

Technical data:

Type: Non-Isolated Step Up Module (BOOST)
Input voltage: DC 10 V to 60 V.
Max. Input current: 30 A (input voltage 10 V to 30 V).
25 A (input voltage 31 V to 60 V).
Quiescent current: 15mA (increases when converting 12V to 20V)
Output voltage: 12V to 90V (adjustable, standard is 19V)
Max. Output current: 20A (based on the input and output voltage difference, the greater the voltage difference, the smaller the output current. Please improve heat dissipation if the current is above 15A)
Constant current range: 0.8A to 20A (+/- 0.3A)
Reverse input protection: yes (150A MOS).
Low voltage protection: yes (V8 to 50V adjustable, self-recovery)
Operating temperature: -40 °C to +85 °C (if the temperature is too high, please improve heat dissipation).
Frequency: 150 kHz.
Conversion efficiency: 92% to 97% (the efficiency refers to the input/output voltage, current and voltage difference. The smaller the difference, the higher the efficiency.)
Input over-current protection: yes (automatically protect when the input is more than 35A and the voltage of the current source does not increase)
Short circuit protection: yes (input 30A fuse).
Wiring method: terminals (please use copper wire with large current)
Max. Output power = input voltage * Maximum current (at input 12 V, the maximum output power is 12 V x 30 A = 360 W).
Size: 130 x 84 x 52 mm/5.11 x 3.3 x 2.04 inches.

Package includes:

1 x module.