Feature

●The Sunfounder RAB breadboard kit is perfectly compatible with Arduino UNO and Mega Board, also for Raspberry Pi 4B, 3B+, 3B, 2B and 1 Model B+ A+
●With the high quality RAB Holder made of long-lasting polyethylene plastic, fixed on a flat table, sturdy and lightweight, enlarging the fun when you create experiments
●Ribbon Cable and T-shape GPIO Extension Board are included, which are special for Raspberry Pi 5 4B, 3B+, 3 Model B, 2 Model B, 1 Model B+, A+
●The 830-tie/point breadboard is included in the kit with an IC area of 630 points, plus two 100-point distribution strips, providing 4 power rails
●Coming with male-to-male 65pcs jumper wires, red, green, and yellow LEDs, ten 1kΩ resistors, a screwdriver, and some screws, especially with 6 rubber feets to keep the RAB holder from slipping


Description

SunFounder RAB holder breadboard kit

Specification:

The wide compatible RAB holder supports your Arduino board and Raspberry Pi and keeps everything comfortable and tidy, free from careless short circuits on a metal desk or caused by metal parts underneath. High-quality solderless breadboard is often used to build and test circuits quickly before completing a circuit design. Flexible jumper cables from plug to plug with a total of 65 pieces in different lengths and colours. You can therefore simply connect them to the control board and the breadboard to form circuits without having to worry about complicated soldering. A T-shaped extension board that extends the pins of the Raspberry Pi, can be plugged directly into a breadboard. The screw holes with thread for easy screwing in. The slots for convenient insertion of wires. The rubber feet effectively prevent the RAB holder.

1.1.
2.2.
3.3.

Box contents:

1 x RAB Holder1 x 830 Point Breadboard1 x T-shaped GPIO Expansion Card1 x 20cm 40-pin Ribbon Cable65 x Jumper Cable10 x 1kΩ Resistor9 x LED (3 red, 3 yellow and 3 green)12 x Screws1 x Screwdriver6 x Rubber Feet