Feature

●Open a 52mm hole in the dashboard and allow a distance of 55mm behind the panel to adjust the gauge
●Connection: green + white - external button, green-n, yellow fuel level, white high beam, purple right turn, blue left turn, red power (+), black power (-), brown oil pressure, orange hazard warning light
●Attach the GPS antenna, preferably outdoors (or inside the windscreen), so that it has a clear view of the sky to receive satellite signal. Connect the antenna cable to the socket on the back of the gauge. Do not cut cables
●Speed: 0-9999 (MPH, knots, km/h adjustable), Mileage: 0-99999 (Mi,NMI,KM available)
●9-32V Operating Voltage, Overspeed Alarm, Buzzer, GPS, Blind Range, Odometer

Description

Product features:

- Suitable for all vehicles, sea ships and off-road vehicles

- The signal comes directly from the satellite signal receiver (GPS antenna), no further speed sensor is required.

- The display has the advantages of high accuracy, quick position confirmation and a short start time.

- IP67 waterproof and dustproof

- Polarity protection and anti-fog performance

- No drift of the comb

- Stepper motors used for the entire range of stepper meters, great functionality with lower power consumption, longer service life, higher accuracy, etc.

Product introduction:


How do I install it? 1. Cut a 52 1/16 inch hole into the board (II) and leave a distance of 55 mm (2 3/16 inches) behind the board to fit the gauge. 2. For the GPS antenna, you should secure it with the black side upwards, preferably outside (or inside the windscreen) so that it has a clear view of the sky to receive the satellite signal. Connect the antenna cable to the female connector on the back of the gauge. And do not cut off any cables.	GPS speedometer keeps counting? 1. After the first installation, the GPS speedometer must search for signals, so the LCD constantly counts numbers. 2. After receiving the signal, the LCD returns to 0. This is normal.	How to adjust the unit? 1. First press the back button for 2-3 seconds and then turn on the power supply 2. Release the button when you see "Unit" 3. Select the desired unit (km/h, mph, knots) 4. After setting, release the button and wait until the menu flashes completely. 5. Turn off the power supply and on again. The speedometer records the setting.

How does the compensation of the GPS tachometer odometer work?

When the device enters a tunnel / bridge without GPS signal, the internal flash memory records the last valid GPS length and latitude.

And the device gets valid GPS length and width when leaving the tunnel/bridge.

The CPU inside calculates the two GPS data to use the algorithm to add the lost odometer in the tunnel/bridge

FAQ:


NO. How do I set the odometer? 1. First press the back button for 2-3 seconds and then turn on the power supply 2. Release the button when you see "ODO"; press the button to change the flashing number from 0 to 99999 to set the target odometer value; 3. After setting, release the button and wait until the menu flashes completely. 4. Turn off the power supply and on again. The speedometer records the setting.	NO. B07JMN4SNN How to reset the daily odometer to zero? First press the back button or external button for 2-3 seconds and then the daily odometer will be reset to zero.	NO. B07JL653P9 How to change "BUZZ"? 1. First press the button for 2-3 seconds and then turn on the power supply 2. Release the button when you see "BUZZ"; press the button to change the flashing number from 10 to 240 to set the target limit value for the overspeed buzzer alarm; 3. After setting, release the button and wait until the menu flashes completely. 4. Turn off the power supply and on again. The speedometer records the setting.