[Rail Support Rod]
Note: Camera slider, ball head and tripod are not included.
The load capacity of the stability arms is up to 10 kg / 22 lb.
Features:
1. Fixed triangle. A pair of support arms on a slider and a tripod form a triangle that represents the most reliable structure for you and your gears. No need to worry that tipping will ruin your masterpiece, and you wont notice that after hours of shooting.2. Versatile A pair of stability arms are stretched from 46 cm to 94.5 cm (18 inches to 37 inches) and meets your requirements when using sliding rails of different lengths. You only need a pair for oblique shooting, time lapse etc3. Easily packed on the go. Even at a weight of 0.98 lb / 0.9 kg, carrying and moving in the wild is a less endurance waste. In addition, 2 stability arms plus 1 tripod perfectly replace 2 tripods. 4. Set up immediately. Screws and youre done. Each end has a wrist so that a three-dimensional triangular structure is available in minutes. So you can efficiently shoot from the air intake over the eye to the sky.5.Do you want to tighten the tripod, but are you afraid that the clamps could damage it? The non-slip rubber pads help you get rid of these worries. It not only increases friction, but also prevents scratches on the tripod legs.
Specifications:
Material: Aviation aluminum alloyColor: SootSize: 52 cm x 3 cm x 3 cm / 20.47 inches x 1.18 inches x 1.18 inches. Maximum load: 10kg/22lbCompatible with: 2.1 inches (5.5 cm) max. Jaw opening for slim and thick tripods.
Package list:
2 x stability arms.
2 x handle clamps.
With the support arms, the possibility of tilting can be greatly reduced and the stability is increased.
As can be seen in the pictures, the slider will be tilted due to obesity due to obesity, but with the stability arms all work stably.
The length can be adjusted from 52 cm to 90 cm (20 to 35 inches), satisfying different situations.
The length of a stability arm is 52 cm (without handle clamp).
The weight of a stability arm is 440 g (without handle clamp).
With two small tilt angles on both ends, these arms can be installed at any angle in one minute.
And with the adjustable C-clamps, they can be easily and firmly attached to various tripods.
|
|
|
|
---|---|---|---|
360° ball head.A 360° rotation allows any angle adjustment, 1/4 screw, compatible. |
Any angle support.Allows a variety of tilt angles to support camera sliders |
Adjustable C-ClampsThe width of the C clamps can change from 10 mm to 50 mm; can grab legs of the most tripod firmly. Maximum load capacity: 10kg/22lb |
Lock firmly.The lock is twist lock, can lock firmly. |
This product increases stability when a slider is used on a single tripod and eliminates the need for a second tripod. It attaches to the tripod with the clamp and fits most tripods. The extendable arm allows you to adjust the slider in a horizontal position or in an angled tilt position.