Your vehicles sensor is sensitive and can be damaged over time by jumping, leaning with your knees on the seat or dropping liquids. The repair is lengthy and expensive, the seat must be exposed, buy a new mat and the seat repadded. The defect in the mat causes the dashboard light to light up. In addition, the activation of this signal causes your car not to pass the vehicle, even if it has no other defects.
Instructions:Installation is very simple. It only takes 1 minute. As a rule, the light goes out by itself when you turn it on, but sometimes it is enough to drive 50 km and the disturbance disappears. If this is not the case, remove the ignition from the vehicle, turn it on again and wait a few seconds for the vehicle to perform the light test again.
Step 1: Pull the old plug out of the mat and hook it out.
Step 2: Take the included emulator.
Step 3: Insert the emulator into the plug in the one-way direction until the part goes all the way in. The process is complete.
IF THIS DOESNT WORK, TRY TO FIX THE ERROR WITH A DIAGNOSIC DEVICE. If this does not work, your car may not be compatible.
Compatible with:
E36 (3) all models.
E46 (3) all models.
E39 (5) all models.
E38 (7) all models.
E53 (X5) all models.
E36 (Z3) all models.
Z4 (models with metal buttons only).
E60 (only with metal keys) an additional module is required (to disable the belt warning sound).
E65 (only with metal keys) an additional module is required (to disable the belt warning sound).
E61 (only with metal keys) an additional module is required (to disable the belt warning sound).