Feature

●The SBC scooter Widia carbide tips are very stable and ideally suited for ski scooters, Nordic blading, skiing...
●Tip 2 mm wide, therefore low risk of breakage
●Tip is made of WIDIA tungsten carbide carbide carbide which can withstand the highest loads.
●For 10 mm barrel ends, on thinner sticks (8-10 mm) with more hot glue can also be mounted
●Glued with hot glue. This ensures a secure hold of the tips and yet easy to install and remove.


Description

The SBC Roller Widia carbide tips are very stable and ideal for ski scooters, Nordic blading, skiing etc.


The special rubber pads for skating on changing surfaces and especially on composite panels (e.g. walkways, in pedestrian areas, coarse asphalt cracks). The stick tip can then no longer jam, which can even lead to the breaking of the stick.

The rubber pad is pulled over the metal tip. The metal tip is still a little bit through the pad and grips when needed, while the pad dampens the impact and noise when the stick is put on.



Installation instructions:

Heat the tip of the existing stick with a hot air dryer (or dip in boiling water) until it can be peeled off the stick.
Brush the tube with melted hot glue, attach the tip immediately and turn to the correct position - allow to cool for a few minutes.