Too sticky or too thick? Hardly shake the gel polish before applying. Or put it in warm water, leave it for a few minutes and then apply. Apply each thin layer is the key, make sure there is not too much gel on the brush before you start applying.3. It is normal that the primer and colour gel remain a little sticky after application, the top layer would seal it.
|
Not dry? Please check the wattage of your lamp. If the wattage is too low, it may not dry or need longer to get out. Recommended wattage: 36 W. Recommended starting time: Primer and each colour layer is cured with UV light for 1 minute or LED for 30 seconds, top layer is cured with UV light for 2 minutes or LED for 60 seconds.
|
Easy to remove? Use a nail file/nail dryer (in front of the base coat) to ensure that your gel is completely dry, clean and free. 2. Applying the base coat is an important step to prevent peeling. Base and top coat should be as thin as possible, otherwise the gel shrinks and peels. Remember to seal the nail edge with each layer. And clean the gel on the cuticle before curing.
|