If you dont have the stamina for a whole wall, a combination of similar stencils can add a bright splash of colour. Large stencils set a stunning accent on an empty wall, try them near a sofa or table or even on the skirting board, almost any wall space that needs that certain something.
With laser cut Mylar film and paint, it is easy for even beginners to produce very high quality stencil work on furniture, walls, floors, fabrics, windows and almost any other flat surface.
Stenciling is fun for the whole family, but be careful, it is very addictive. How to stencil:
Virtually any paint can be used to stencil with stencils, but the two most popular types are acrylic and dry brush oil.
Preparation:
Always ensure that the surface to be stenciled is clean and properly prepared without flaking paint.
Instructions:
Spray the back of the stencil lightly with spray adhesive and position the stencil on the chalk line or registration mark.
Painting: dip your brush or sponge in the paint and wipe most of it on a piece of kitchen paper. If you use too much paint, you will find that it bleeds behind the stencil and gives the pattern very torn edges.
Apply the paint with an up and down tipping motion, start on the outside of each stencil and work towards the middle.
Cleaning: wash your stencil frequently in hot soapy water, especially when changing color. Dont forget to check the back of the stencil for colour. To remove oil paint and glue from your stencils and brushes, soak them in turpentine for a few minutes.